Operating Regulations of Steel Bar Straightening Machine

1. The equipment must be taken care of by a special person, and work with a certificate.
2. The operator is not allowed to leave the machine too far during the operation, and the rebar straightening machine must be shut down during winding, threading, and head cutting.
3. In the process of straightening the steel bar, when the steel bar jumps out of the tray guide trough, cannot reach the fixed-length mechanism, or the messy wire or the steel bar falls off, press the limit switch in time to stop cutting the steel bar, and use it after adjustment.
4. When adjusting each rebar to the end of straightening short rebars, you should hold the casing to escort the rebars to the guide and the straightening barrel to avoid accidents when they swing freely.
5. Before the straightening mold is fixed and the protective cover is not covered, it is not allowed to penetrate the steel bars to prevent the straightening mold from flying out and hurting people after the machine is started.
6. During the operation of the machine, it is forbidden to adjust the rollers, operate with gloves, and perform maintenance operations during the operation of the machine.
7. The straightened and cut steel bars should be stacked in small bundles according to the specifications and the number of roots. They are not allowed to pile up in a random manner to prevent quality accidents due to different steel components and properties. The power supply must be cut off after the operation is completed.
8. Strictly implement the "Cross Operation Policy" to ensure that the machinery is in good working condition.